Molded from ABS plastic and professionally upholstered, these A-pillar gauge pods are perfect for holding a single gauge. Unlike the typical A-pillar pod, this pod is designed to be positioned at the lowest point possible without blocking the defrost vent. The pod fits 2 1/16” (52mm) gauges of any type. The pod is large enough to accommodate mounting brackets, wire and tubing with ease. A built in wire trail is used to cleanly route wires and tubing below the dashboard.

Installation is solid and simple. Designed to wrap securely around the A-pillar, tabs of excess fabric extend from 3 mounting points. Use contact cement, hot glue, Velcro, or tape to attach the mounting tabs to the back of the car's A-pillar. This product requires no permanent modification and leaves the A-pillar in original condition.

Some 2001 and later VW vehicles use A-pillar mount airbags. A-pillar pods should not be used on these vehicles.

Pod & Gauge Package Deal: Add a NewSouth Boost Gauge and save $10! Gauge kit is pre-wired, and is complete with tubing and connectors!

Dual A-Pillar Pods:

Same in construction as the single gauge pod, the dual gauge pod system allows the installation of a second gauge cleanly and simply. The dual pod system simply adds an 'upper pod' to the single pod to create a dual pod. The 'single' and 'upper' pods must be ordered separately.